GREAT PLANES Christen Eagle .46 Instruction Manual page 19

❏
10. Attach the engine to the mount using four 6-32 x 3/4"
[19mm] screws, four #6 fl at washers and four #6 lock washers.
❏
11. Install your muffl er onto the engine.
❏
12. Cut the fuel tubing coming from the tank to the proper
length and connect the pressure and carb lines to the engine.
The fi ll line (if installed) should be plugged with the included
fuel line plug. A plywood fi ll line clip is included and is glued
together as shown. Be sure to fuel proof the clip with epoxy
or CA glue. Securely glue the clip in the location shown and
route the fi ll line through the clip.
❏
13. Cut four arms from a fi ve-armed servo arm included
with your throttle servo. Center the servo with your radio
system (throttle stick positioned at 50% throttle) and install
the arm perpendicular to the servo case. Install a screw-
lock pushrod connector into the outer hole in the remaining
arm and secure it in place with a nylon screw-lock connector
retainer. Loosely install a 4-40 x 1/4" SHCS set screw into the
screw-lock pushrod connector.
❏
14. Install the throttle servo onto the servo tray using the
hardware supplied with the servo.
❏
15. Drill a 3/16" [4.8mm] hole for the throttle pushrod in
the fi rewall and the second former inline with the throttle arm
on the carburetor. An extra long drill bit is very useful for this
step (drill bit shown is stock number HIGR1020). Be sure
that you do not drill into the fuel tank if the throttle arm on
your engine is located in a different position than the one
shown in the picture.
19