Table of Contents
Advertisement
RECOMMENDED
ACCESSORIES
WARNINGi
o Use only accessories
recommended
for this miter saw. Follow
instructions
that accompany
accessories.
Use of improper
accessories
may cause hazards,
o The use of any cutting
tool except
10 in. saw blades
which
meet the
requirements
under recommended
accessories
is prohibited.
Do not
use accessories
such as shaper
cutters
or dado sets, Ferrous
metal
cutting
and the use of abrasive
wheels
is prohibited.
o Do not attempt
to modify
this
tool or create accessories
not
recommended
for use with this tool.
Any such alteration
or modification
is misuse
and could result
in a
hazardous
condition
leading
to
possible
serious injury.
ACCESSORIES
Visit your Sears Hardware Department
or see the Sears Power and Hand Tool
Catalog to purchase recommended
accessories
for this power tool.
[_WARNING
i
o To avoid the risk of personal
injury,
do not modify
this power tool or use
accessories
not recommended
by
Sears.
o Read warnings
and conditions
on
your CARBIDE
TIPPED SAW BLADE.
Do not operate
the saw without
the
proper
saw blade guard in place.
Carbide
is a very hard but brittle
material.
Care should
be taken while
mounting,
using, and storing
carbide
tipped
blades
to prevent
accidental
damage.
Slight shocks,
such as
striking
the tip while
handling,
can
seriously
damage
the blade. Foreign
objects
in the workpiece,
such as
wire or nails, can also cause
tips
to crack or break off. Before
using,
always
visually
examine
the blade
and tips for bent blade, cracks,
breakage,
missing
or loose tips, or
other damage.
Do not use if damage
is suspected.
Failure
to heed safety
instructions
and warnings
can
result
in serious
bodily
injury.
BLADE
iNFORMATION
o Always use a crosscut blade that is
designed for cutting across the wood
grain. NEVER use Rip, Combination,
Plywood,
Dado or Abrasive type saw
blades at any time
o Always use a 10 in. diameter blade with
either a 5/8" arbor hole, speed rating
must be at least 4800 RPM.
o Read and understand
all instructions
provided with each blade before using
on this miter saw.
There are two main materials
used for
saw blades; high-speed
steel (HSS) and
carbide tipped (TCT). While the HSS
blades are generally
less expensive
than carbide tipped, TCT blades wilt
stay sharper
longer than HSS. As a
general rule the more teeth per inch (TPI)
the smoother
the cut. Please read the
information
provided on the blade for
more details for their use.
General Purpose Wood Cutting: 24 - 40 TPI
Fine Woodworking
Cutting: 60 - 80 TPI
Non-ferrous
Metal Cutting:
Use only special blades designed for
cutting this type of material.
Plastic Cutting:
Use only special blades designed for
cutting plastic.
NOTE: When cutting non-ferrous or
plastic, be sure to clean up completely
after each use. Take special care with
metal shavings
after each cut, these can
cause damage to the table top. ALWAYS
WEAR EYE PROTECTION.
Hide quick links:
Advertisement
Table of Contents
