Fit And Remove Variable Loading Floor; Fixing Set - Skoda Superb 2014 Owner's Manual

The variable loading floor can be pulled out a little more before dividing the
boot with the variable loading floor
tween the rear seats and the separation.
CAUTION
Ensure that the raised front edge of the variable loading floor is not damaged.

Fit and remove variable loading floor

Fig. 114 Boot: Fold up variable loading floor
Fig. 115 Boot: remove variable loading floor

Read and observe on page 103 first.
The variable loading floor can be removed and reinstalled, if necessary.
Removing
›
Grasp the rear part of the floor by the handle, raise it slightly in the direction
of the arrow » Fig. 114 and pull it out over the bumper in the direction of
1
the arrow until it engages in the opening
2
104
Operation
» page 103. This enlarges the space be-
» Fig. 115.
C
›
Fold up the loading floor by moving it in the direction of the arrow
» Fig. 114.
3
›
Press the safety buttons » Fig. 115
A
Fitting
›
Fold up the floor and place it on the carrier rails.
›
Push the floor forwards until it engages in the openings
rails » Fig. 115.
›
Carefully press in the vicinity of the openings
to place, if necessary press the safety buttons
WARNING
Ensure the variable loading floor is attached correctly during installation. If
this is not the case, there is a risk of injury for the occupants.

Fixing set

Fig. 116 Telescopic pole and tensioning strap

Read and observe on page 103 first.
The fixing set can be used for dividing the boot or for securing the objects
which are being transported.
Telescopic pole
›
Insert the holders for the telescopic pole into the left and right openings of
the carrier rails.
›
Press the top part of the holder in the direction of the arrow
simultaneously push in the desired position in the direction of the arrow
›
Ensure that the holder is correctly locked in place.
and remove the floor.
in the carrier
B
on the floor until it clicks in-
C
.
A
» Fig. 116
1
and
.
2
