Replacing Windscreen Wiper Blades - Skoda Superb 2014 Owner's Manual

Table of Contents

Advertisement

Note
It is necessary after each emergency operation to move the sliding/tilting
roof into the basic position.
This is why the rotary switch must be set to posi-
1)
tion
» Fig. 45
on page 62 and pressed forwards for about 10 seconds.
A
After each emergency operation, it is necessary to activate the
roof
» page
214.
2)
Activation after un-clamping and re-clamping the battery
The panoramic sliding/tilting roof (referred to form now on as just the sliding/
tiling roof) and the sun screen must be activated after disconnecting and re-
connecting the battery.
To activate the sliding/tilting roof, press the notch on the control dial down-
wards and forwards for approx. 10 seconds.
To activate the sun screen, press and hold the switch
page 64for approx. 10 seconds.
If the sliding/tilting roof or sun screen is not fully closed or pushed shut when
disconnecting and reconnecting the battery, they must first be closed or push-
ed shut
» page
64, Opening/closing the sun screen
then is it possible to perform the activation.

Replacing windscreen wiper blades

Introduction
This chapter contains information on the following subjects:
Replacing the windscreen wiper blades
Replacing the rear window wiper blade
WARNING
Replace the windscreen wiper blades once or twice a year for safety rea-
sons. These can be purchased from a ŠKODA Partner.
1)
Applies to emergency operation of the Superb sliding/tilting roof.
2)
Applies to emergency operation of the Superb Combi sliding/tilting roof.
214
Do-it-yourself
Before replacing the windscreen wiper blade, put the windscreen wiper arms
into the service position.
» Fig. 47
on
G
Service position for changing wiper blades
» page
64, Operation. Only
The windscreen wiper arms move into the service position.
Removing the wiper blade
214
215
Fitting the wiper blade
The windscreen wiper arms move into the home position.
Replacing the windscreen wiper blades
Read and observe
on page 214 first.
Closing the bonnet.
Switch the ignition off and on again.
Within 10 seconds, press the lever in position
onds
» Fig. 62
on page 76.
Lift the windscreen wiper arm away from the windscreen.
Hold the upper part of the wiper arm and unlock the securing mechanism
» Fig.
194.
1
Remove the wiper blade in the direction of the arrow
Push the wiper blade in until it latches on the stop.
Check that the wiper blade is correctly attached.
Fold the wiper arm back to the windscreen.
Turn on the ignition and press the lever into position
Fig. 194
Windscreen wiper blade
and hold it for around 2 sec-
4
.
2
» Fig. 62
on page 76.
4

Advertisement

Table of Contents
loading

This manual is also suitable for:

Superb

Table of Contents