Table of Contents
Advertisement
The system cannot be activated because a fault exists on the vehicle. Seek
help from a specialist garage.
Park Assist stopped. System currently unavailable.
The parking procedure was ended because a fault exists on the vehicle. Seek
help from a specialist garage.
Park Assist faulty. Workshop!
The parking procedure is not possible because a fault exists in the system.
Seek help from a specialist garage.
ASR intervention. take over steering!
The parking procedure is terminated by a TCS intervention.
PARK ASSIST Turn on turn signal and select reverse gear
The prerequisites for manoeuvring out of a parking space using the system
have been met. Switch on the turn signals and shift into reverse.
Automatic space departure not possible. Space too small.
The manoeuvring procedure using the system is not possible. The parking gap
is too small.
Park Assist: Brake interv. Speed too high.
The speed was too high during the parking and was automatically reduced.
Cruise Control System
Introduction
This chapter contains information on the following subjects:
Activating/deactivating
Storing and maintaining speed
Changing the stored speed
Switching off temporarily
The Cruise Control System (CCS) maintains a set speed, more than 25 km/h,
without you having to actuate the accelerator pedal.
This is only possible within the range which is permitted by the power output
and braking power of the engine.
The warning light
illuminates in the instrument cluster when the cruise con-
trol system is switched on.
158
Driving
WARNING
For safety reasons, the cruise control system must not be used in dense
■
traffic or on unfavourable road surfaces (such as icy roads, slippery roads,
loose gravel) – risk of accident!
The saved speed may only be resumed if it is not too high for the current
■
traffic conditions.
Always deactivate the cruise control system after use to prevent the sys-
■
tem being switched on unintentionally.
CAUTION
The cruise control system is not able to maintain a constant speed when
■
driving in areas with steeper gradients. The weight of the vehicle increases the
speed at which it travels. In such cases, select a lower gear or brake the vehi-
cle using the footbrake.
The cruise control system cannot be activated when first gear or reverse
■
gear is selected (vehicles with manual transmission).
The cruise control system cannot be activated when the selector lever is in
■
positions P, N or R (vehicles with automatic transmission).
The cruise control system may automatically switch off when some brake as-
■
sist systems (e.g. ESC) intervene, when the maximum permissible engine
speed is exceeded, etc.
Activating/deactivating
158
159
159
159
Read and observe
Activating
›
Move switch
» Fig. 150
A
Deactivating
›
Move switch
» Fig. 150
A
Fig. 150
Operating lever: Cruise control
system controls
and
on page 158 first.
into the ON position.
into the OFF position.
Advertisement
Chapters
Table of Contents
