Voice Control - Skoda Superb 2014 Owner's Manual

■ Delete lists - Delete device lists
Known devices - Delete the list of known devices
■
Device blocked - Delete the list of blocked devices
■
■ Both lists - Delete both device lists
Password - Use of password to log on to the WLAN network
■
Show - Display a password to log on to the WLAN network
■
■ Generate - Generate a new password to log on to the WLAN network
WLAN name - Use of WLAN network name
■
Show - Display the WLAN network name
■
■ Rename - Rename the WLAN network
WPS config. - Wi-Fi network connection using WPS
■
Pushbutton - Automatic connection
■
WPS PIN - PIN entry for the connection
■
Data counter - Display information about the volume of data transferred
■
Act Conn. - display of the volume of data transferred for the current con-
■
nection
Total - Display the total volume of data transferred
■
Reset - Reset the information about the volume of data transferred
■
Settings - WLAN network settings
■
Access point - Access point settings
■
■ Settings - Access point management
APN - Change the access point name
■
User name - User Name
■
■ Password - Password
Reset - Reset access point factory settings
■
Prioritisation - Set the connection priority
■
■ Calls - Set the connection priority for calls
Data - Set the connection priority for data transfer
■
Encryption- Set the encryption
■
■ WPA2 - Enable WPA 2 encryption
Open - No encryption
■
Visibility - Set the WLAN network visibility
■
■ Visible - WLAN network is visible to other devices
Invisible - WLAN network is not visible to other devices
■
Data roaming - Set the data roaming
■
■ No roaming - Data roaming is not allowed
Allow - Data roaming is allowed
■
Always ask - Question setting for data roaming
■
■ WLAN channel - Select WLAN network channels (preferably set to channel
11)
Channel 1 ... Channel 11 - Display the WLAN network channels
■
■ Reset - Reset Wi-Fi network factory settings

Voice control


Introduction
This chapter contains information on the following subjects:
Dialogue
Voice commands - GSM II
Voice commands - GSM III
Dialogue
Fig. 129 Multifunction steering wheel
The voice control system (hereinafter referred to as the system) makes it pos-
sible to use voice commands for some functions of the hands-free system.
The period of time during which the system is ready to receive voice com-
mands and to carry them out is called a dialogue. The system gives audible
feedback and guides you if necessary through the relevant functions.
Optimum understanding of the voice commands depends on several factors.
›
Speak with a normal tone of voice without intonation and excessive pauses.
›
Avoid a bad pronunciation.
›
Close the doors, windows and sliding roof, to reduce or stop disturbing exte-
rior noise.
›
You are recommended to speak louder at higher speeds, so that the sound of
your voice is not drowned out by the increased ambient noise.
Communication and multimedia
129
130
131

129