Table of Contents

Advertisement

The display shows the following
The search area for the parking space on the driver's side is automatically indi-
cated on the display.
Activate the turn signal on the driver's side if you wish to park on this side of
the road. In the display the search area for the parking space is indicated on
the driver's side.
If suitable parking space is found, its parameters are stored until another suit-
able parking space has been found or until a distance of 10 m had been driven
after finding the parking space.
To change the parking mode when searching for a parking space, press the 
symbol button again.
Note
If the symbol  (km / h) is shown in the display , the vehicle speed should be
reduced below 40 km / hr (parallel parking) or below 20 km / hr (Transverse

parking) .

Parking
Fig. 149 Display
Read and observe
and
Display
Parking place recognised with the information to drive on.
A
Parking place recognised with the information to engage the reverse gear.
B
Indication for selecting the forward gear.
C
Indication for selecting the reverse gear.
D
156
Driving
» Fig. 148
- .
on page 155 first.
If the system has recognised a suitable parking space, this parking space is
shown in the display
» Fig. 149
- .
Continue driving forwards until the display appears
Stop and make sure that the vehicle does not move forward until the start of
the parking procedure.
Select reverse gear or move the selector lever into position R.
As soon as the following message is shown in the display: Steering int. ac-
tive. Monitor area around veh.!, let go of the steering wheel. The steering
will be taken over by the system.
Observe the direct vicinity of the vehicle and reverse carefully.
If necessary, the parking procedure can be continued with further steps.
If the display of the arrow forward flashes
move the selector lever into position D.
The display shows the  icon (brake pedal).
Depress the brake pedal and wait until the steering wheel automatically ro-
tates into the required position, the symbol  goes out.
Carefully drive forwards.
If the backwards arrow is flashing in the display
gear again or move the selector lever into position R .
The display shows the  icon (brake pedal).
Depress the brake pedal and wait until the steering wheel automatically ro-
tates into the required position, the symbol  goes out.
Carefully move backwards.
These steps can be repeated several times one after the other.
As soon as the parking procedure is completed, an audible signal sounds and
the following message appears in the display.
Park Assist stopped. take over steering!
Automatic brake assist in speeding
If a velocity of 7 km / h is exceeded during the parking manoeuvre for the first
time, the speed will be automatically reduced by the system to less than 7 km /
h. This prevents the parking manoeuvre from aborting.
Automatic termination
The system cancels the parking procedure if one of the following cases occurs:
A speed of 7 km / h is exceeded for the second time.
The time limit of 6 minutes is exceeded.
The system key is pressed.
» Fig. 149
- .
» Fig. 149
- , then 1 Select gear or
» Fig. 149
- , select reverse

Advertisement

Table of Contents
loading

This manual is also suitable for:

Superb

Table of Contents