Parking Aid - Skoda Superb 2014 Owner's Manual

The HBA function is automatically deactivated when the brake pedal is re-
leased.
The ABS is activated faster and more effectively with the intervention of the
HBA.
Hill Hold Control (HHC)

Read and observe and
When driving on slopes, HHC allows you to move your foot from the brake ped-
al to the accelerator pedal without having to use the handbrake.
The system holds the brake pressure produced by the activation of the brake
pedal for approx. 2 seconds after the brake pedal is released.
The brake pressure drops gradually the more you operate the accelerator ped-
al. If the vehicle does not start off within 2 seconds, it starts to roll back.
The HHC is active on slops of >5 % if the driver door is closed. HHC is only ever
active on slopes when in forward or reverse start off. When driving downhill, it
is inactive.

Parking aid


Introduction
This chapter contains information on the following subjects:
Function
Activation/deactivation
WARNING
The parking aid is not a substitute for the driver paying proper attention
■
and it is always the driver's responsibility to take care when reversing the
vehicle or carrying out similar manoeuvres. Pay particular attention to small
children and animals as they may not be recognised by the system sensors.
Before reversing, you should make sure that there are no small obstacles,
■
such as rocks, thin posts, trailer drawbars etc. in front or behind your vehi-
cle. Such obstacles may not be recognised by the system sensors.
on page 151 first.
WARNING (Continued)
Under certain circumstances, surfaces of certain objects and types of
■
clothing cannot reflect the system signals. Thus, these objects or people
who wear such clothing are not recognised by the System sensors.
External sound sources can have a detrimental effect on the system. Un-
■
der adverse conditions, this may cause objects or people to not be recog-
nised by the system.
CAUTION
If a warning signal sounds for about 3 seconds after activating the system
■
and there is no obstacle close to your car, this indicates a system fault. The
fault is also indicated by the symbol flashing in the button
page 154 . Seek help from a specialist garage.
The sensors must be kept clean (free of ice, etc.) to enable the system to op-
■
erate properly.
Under adverse weather conditions (heavy rain, water vapour, very low or
■
high temperatures etc.) system function may be limited.
Additionally installed modules such as bicycle carriers can impair the function
■
of the parking aid.
Note
The signal tones for front obstacle recognition are factory-set to be higher
■
than for rear obstacle recognition.
If not all fields around the vehicle are shown after the system is activated,
■
the vehicle will need to be moved a few metres forwards or in reverse.
The sound of the park-assist can be adjusted via the MAXI DOT display in the
■
154
Wizards menu option » page
154
If the system is activated and the selector lever of the automatic gearbox is
■
in position P (the vehicle cannot move), the warning tone is interrupted and no
obstacles are displayed.
» Fig. 147
45.
Assist systems
on
153