Replace A Power Supply; Replace An Ac Power Supply; Replace A Dc Power Supply - Dell Z9000 Installing

Hide thumbs Also See for Z9000:
Table of Contents

Advertisement

To install a new power supply, follow the steps below:
The power supply modules should slide into the slots smoothly. Do not force a module into a slot. This
may damage the power supply or the Z9000 chassis.
Step
Task
Take the power supply unit out of the shipping box.
1
Remove the small plastic cover over the DC cable connectors. Do not throw the cover away; you will replace it
2
when installation is complete.
Ensure that the DC power source is turned OFF.
3
Using the grab handle, slide the unit into the power supply bay.
4
Tighten the securing screw on the side of the PSU.
5
Attach power cables.
6
Replace the small plastic cover over the DC cable connectors.
7
Turn the DC power source ON.
8

Replace a power supply

NOTE: If a power supply fails, it must be completely replaced. There are no field servicable components in the
module itself. Refer to
NOTE: If using a single PSU, you must install a blank plate in the other PSU slot. Dell Force10 recommends
using PSU0, if installing only one power supply.

Replace an AC power supply

To replace a power supply, follow the steps below:
Step
Task
Disconnect the power cable from the power supply.
1
Use the grab handle to slide the unit out of the power supply bay.
2
Using the grab handle on the replacement unit, slide it into the power supply bay.
3
Tighten the securing screw on the side of the PSU. Ensure that the module is secure.
4
Attach power cable to the new module.
5
The system powers up as soon as the cables are connected between the power supply and the power source.
6

Replace a DC power supply

To replace a power supply, follow the steps below:
Step
Task
Turn the DC power source OFF.
1
Remove the small plastic cover over the DC cable connectors. Do not throw the cover away; you will replace it
2
when installation is complete.
Disconnect the power cable from the power supply.
3
Use the grab handle to slide the unit out of the power supply bay.
4
Chapter 9, Technical Support
to request a hardware replacement.
Power Supplies
|
27

Advertisement

Table of Contents
loading

This manual is also suitable for:

Force10 z9000

Table of Contents