Dell Z9000 Installing page 44

The European WEEE symbol
In accordance with the European WEEE Directive, electrical and electronic equipment (EEE) is to be
collected separately and to be reused, recycled, or recovered at end of life. Users of EEE with the WEEE
marking per Annex IV of the WEEE Directive, as shown above, must not dispose of end of life EEE as
unsorted municipal waste, but use the collection framework available to customers for the return,
recycling and recovery of WEEE. Customer participation is important to minimize any potential effects
of EEE on the environment and human health due to the potential presence of hazardous substances in
EEE.
Dell Force10 Networks products, which fall within the scope of the WEEE, are labeled with the crossed-
out wheelie-bin symbol, as shown above, as required by WEEE.
For information on Dell Force10 product recycling offerings, see the WEEE Recycling instructions on
iSupport at: https://www.force10networks.com/CSPortal20/Support/WEEEandRecycling.pdf.
For more information, contact the Dell Force10 Technical Assistance Center (TAC) (see
Technical Assistance
SD card removal
The SD card can be removed and re-installed, to support high security environments. Dell Force10
Networks recommends the card be removed only when necessary. It should only be removed and
replaced by authorized personnel.
CAUTION: The SD card should only be removed to support high security operations and after discussions
with Dell Force10 Technical Support or your Dell Force10 representative.
To open the case and remove the SD card:
Remove the small phillips screws that connect the top to the body. The screws are located on the top
1
and the sides of the chassis.
Slide the top backwards until its front flange slides free of the faceplate, then lift it off.
2
Gently push the SD card to release it from the slot.
3
44 | Z9000 Specifications
Center).
Contacting the