Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Dell VEP1400 Series
Summary of Contents for Dell VEP1400 Series
- Page 1 , E42W VEP1400 Setup Guide...
- Page 2 A WARNING indicates a potential for property damage, personal injury, or death. © 2018 Dell Inc. or its subsidiaries. All rights reserved. Dell, EMC, and other trademarks are trademarks of Dell Inc. or its subsidiaries. Other trademarks may be trademarks of their respective owners.
-
Page 3: Table Of Contents
Contents 1 About this guide............................. 4 Related documents................................4 Information symbols................................4 2 Site preparations............................5 Site selection..................................5 Chassis mounting................................5 System ground................................... 5 Fans and airflow................................. 5 Power....................................6 Storing components................................6 3 VEP1400 installation............................7 Unpack....................................7 Platform power-up................................7 Power up sequence.............................. -
Page 4: About This Guide
For more information about the Virtual Edge Platform 1400 (VEP1400), see the following documents: • VEP1400 Installation Guide • VEP1400 Release Notes NOTE: For the most recent documentation, see the support site: www.dell.com/support. Information symbols This book uses the following information symbols: NOTE: The Note icon signals important operational information. CAUTION: The Caution icon signals information about situations that could result in equipment damage or loss of data. -
Page 5: Site Preparations
The VEP1400 supports desktop placement (rubber feet), wall mount (using brackets) and rack-mount using a dual-unit tray. System ground Dell recommends grounding your system. Use VEP4600 in a CBN. Fans and airflow Fan installation is done as part of the factory install based on stock keeping unit (SKU) type. VEP 4600 supports an AC normal fan unit with fan airflow from the I/O to the PSU. -
Page 6: Power
For proper ventilation, position the platform in an equipment rack or cabinet with a minimum of 5 inches (12.7 cm) of clearance around the exhaust vents. The fan speed varies based on internal temperature monitoring. The platform never intentionally turns off the fans. Power Connect the platform to the applicable power source using the appropriate power cable. -
Page 7: Vep1400 Installation
VEP1400 installation To install VEP1400, complete the installation procedures in the order presented in this section. Always handle the platform and its components with care. Avoid dropping the platform or any field replaceable units (FRUs). NOTE: ESD damage can occur if components are mishandled. Always wear an ESD-preventive wrist or heel ground strap when handling the platform and its components. -
Page 8: Power Up Sequence
NOTE: A US AC power cable is included for powering up an AC power supply. You must order all other power cables separately. NOTE: If the components are mishandled, ESD damage can occur. Always wear an ESD-preventive wrist or heel ground strap when handling the platform and its components. -
Page 9: Specifications
Specifications This section lists the VEP4600 specifications. CAUTION: Operate the product at an ambient temperature not higher than 0°C to 45°C (32°F to 113°F). CAUTION: Lithium Battery Caution: There is a danger of explosion if the battery is incorrectly replaced. Replace only with same or equivalent type of battery. - Page 10 Typical power consumption ATTENTION REVIEWERS: Need verification on the total power consumption as it is not included in the Source book yet. NOTE: For the most current AC power requirements and power consumption specifications, see the Installation Guide at www.Dell.com/support. Specifications...
-
Page 11: Support
The support site provides integrated, secure access to these services. To access the support site, go to www.dell.com/support/. To display information in your language, scroll down to the bottom of the web page and select your country from the drop-down menu.