Install A New Ac Power Supply; Install A New Dc Power Supply - Dell Z9000 Installing

CAUTION: Be sure that the DC power source is turned OFF before attaching the cables to the DC connectors
on the Z9000.
Power Supply 0 (PSU0) is on the top; Power Supply 1(PSU1) is on the bottom.

Install a new AC power supply

Figure 5-1. AC Power Supply
PSU0
PSU1
Cable
Grab
Connector
Handle
To install a new power supply, follow the steps below:
The power supply modules should slide into the slots smoothly. Do not force a module into a slot. This
may damage the power supply or the Z9000 chassis.
Step Task
Take the power supply unit out of the shipping box.
1
Using the grab handle, slide the unit into the power supply bay.
2
Tighten the securing screw on the side of the PSU.
3
Attach power cables.
4
The system powers up as soon as the cables are connected between the power supply and the power source.
5

Install a new DC power supply

Figure 5-2. DC Power Supply
PSU1
DC cable
connectors
26 | Power Supplies
Fan Modules
Securing
Screw
PSU0
Fan Modules
Securing
Screw
Grab
Handle