Table of Contents
Advertisement
EP-61BXC-A
Section 3-2
System Memory Configuration
Memory Layout
The EP-61BXC-A supports (3) 168-pin DIMMs (Dual In-line Memory Module).
The DIMMs can be either EDO (Extended Data Out) or SDRAM (Synchronized
DRAM).
•
We recommend using SDRAM DIMM can not mixing
with EDO DIMM modules together at 66MHz.
•
The EDO DIMM only support pentium
support Deschutes Processor at 100MHz.
•
256MB only Support Registered synchronous DRAM Memory
Modules. The Registered SDRAM DIMM do not mix with SDRAM
DIMM modules together.
•
We recommend when installed the 100MHz Deschutes Processor
using DIMM SDRAM must be 125MHz (-8ns) bus speed. If used
100MHz (-10ns) SDRAM may be critical timing for the
motherboard.
•
About the "PC/100 SDRAM spec." information you may visit Inte's
home page at:
http//developer.intel.com/design/pcisets/memory/index.htm
•
DIMM SDRAM may be 83MHz (-12ns), 100MHz (-10ns) or
125MHz (-8ns) bus speed.
Figure 2 and Table 1 show several possible memory configurations using
DIMM 1 (M1)
DIMM 2 (M2)
DIMM 3 (M3)
F igu re 2
Installation
®
II Processor at 66MHz, not
B ank 0
-Sy n chronou s
B ank 1
-SD R A M or E D O
D IM M
B ank 2
Page 3-5
Advertisement
Table of Contents
