Load Setup Defaults; Integrated Peripherals - EPOX EP-61BXC-A User Manual

BIOS
The default is Enabled.
Enalbed: Provides IRQ for USB device.
Disabled: Release IRQ for other device.

4-6 Load Setup Defaults

The "LOAD SETUP DEFAULTS" function loads the system default data directly
from ROM and initializes the associated hardware properly. This function will be
necessary only when the system CMOS data is corrupted.

4-7 Integrated Peripherals

IDE HDD Block Mode
IDE Primary Master PIO
IDE Primary Slave PIO
IDE Secondary Master PIO
IDE Secondary Slave PIO
IDE Primary Master UDMA
IDE Primary Slave UDMA
IDE Secondary Master UDMA
IDE Secondary Slave UDMA
Onboard Primary PCI IDE
Onboard Secondary PCI IDE
USB Keyboard Support
POWER ON Method
KB Power ON Password
Hot Key Power ON
KBC Input Clock
Onboard FDD Controller
Onboard Serial Port 1
Note: If you do not use the Onboard IDE connector, then you will need to
set Onboard Primary PCI IDE: Disabled and Onboard Secondary PCI
IDE: Disabled
Note: The Onboard PCI IDE cable should be equal to or less than 18
inches (45 cm.).
IDE HDD Block Mode: IDE Block Mode allows the controller to access blocks
of sectors rather than a single sector at a time.
The default is Enabled.
Page 4-18
ROM PCI/ISA BIOS(2A69KPA9)
INTEGRATED PERIPHERALS
AWARD SOFTWARE, INC.
: Enabled Onboard Serial Port 2
: Auto Onboard IR Controller
: Auto Onboard Parallel Port
: Auto Onboard Parallel Mode
: Auto ECP Mode Ise DMA
: Auto Parallel Port EPP Type
: Auto
: Auto
: Auto
: Enabled
: Enabled
: Disabled
: Hot Key
: Enter
Esc : Quit
: Ctrl-F1
: 12MHz
F1 : Help
: Enabled
F5 : Old Values
: Auto F7 : Load Setup Defaults
Figure 8: Integrated Peripherals
EP-61BXC-A
: Auto
: Disabled
: 378/IRQ7
: ECP / EPP
: 3
: EPP1.9
é é é é é ê ê ê ê ê è
è è è ç ç ç
è ç ç : Select Item
PU/PD/+/- : Modify
(Shift) F2 : Color