Table A.1: Watchdog Timer Registers - Advantech GMB-910 User Manual

Table A.1: Watchdog Timer Registers

Address of register (2E) Attribute
Read/Write
87 (hex)
07 (hex)
30 (hex)
F5 (hex)
Write 0 to bit 3: set second as counting unit. [default]
Write 1 to bit 3: set minute as counting unit.
F6 (hex)
F7 (hex)
AA (hex)
GMB-910 User Manual
Value (2F) and description
- Write this address to I/O address port
2E (hex) twice to unlock the W83627HF
write Write 08 (hex) to select register of
watchdog timer.
write Write 01 (hex) to enable the function of
the watchdog timer. Disabled is set as
default.
write Set seconds or minutes as units for the
timer.
write 0: stop timer [default]
01~FF (hex): The amount of the count,
in seconds or minutes, depends on the
value set in register F5 (hex). This num-
ber decides how long the watchdog
timer waits for strobe before generating
an interrupt or reset signal. Writing a
new value to this register can reset the
timer to count with the new value.
read/write Bit 6: Write 1 to enable keyboard to
reset the timer, 0 to disable.[default]
Bit 5: Write 1 to generate a timeout sig-
nal immediately and automatically
return to 0. [default=0]
Bit 4: Read status of watchdog timer, 1
means timer is ""time out""."
- Write this address to I/O port 2E (hex)
to lock the watchdog timer.2.
58