Connecting Wires To Terminals - Kenwood KDV-415U Instruction Manual

Connecting Wires to Terminals

AV input
Use of the optional cable CA-C3AV
is recommended for connecting an
external player.
USB connector
Front side
Wiring harness
(Accessory1)
White
White/Black
Gray
Gray/Black
Green
Green/Black
Purple
Purple/Black
Power control/Motor antenna control wire
(Blue/White)
TEL mute wire (Brown)
Motor antenna control wire (Blue)
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
Parking sensor wire (Light Green)
PRK SW
Parking sensor wire
Junction cable
(Light Green)
(Accessory3)
R
Fuse (10A)
To Kenwood disc changer/ External optional accessory
⁄
To connect these leads, refer to the relevant instruction manuals.
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
If no connections are made, do not let the wire come out from the tab.
Connect either to the power control terminal when using the optional
power amplifier, or to the antenna control terminal in the vehicle.
P.CONT
Connect to the terminal that is grounded when either the telephone rings
MUTE
or during conversation.
⁄
To connect the Kenwood navigation system, consult your navigation
manual.
Depending on what antenna you are using, connect either to the control
ANT.
CONT
terminal of the motor antenna, or to the power terminal for the booster
amplifier of the film or short pole-type antenna.
Car fuse box
ACC
Visual output (Yellow)
FM/AM antenna input
Front output
L
Rear output/ Sub Woofer output/
AV output (audio)
Do not connect.
Ignition key switch
Car fuse box
(Main fuse)
Battery
For the sake of safety, be sure to
connect the parking sensor.
⁄
Connect to the vehicle's
parking brake detection
switch harness.
|
English
37