X'over Setting; Dta (Digital Time Alignment) Setting - Kenwood KDV-415U Instruction Manual

X'Over Setting

You can set a X'Over value for the speakers;
Setting item
Front High Pass Filter
>
"FRONT" "FC"
Rear High Pass Filter
>
"REAR" "FC"
Front High Pass Slope
>
"FRONT" "SLOPE"
Rear High Pass Slope
>
"REAR" "SLOPE"
Subwoofer Low Pass Filter
>
"SUB-W" "FC"
Subwoofer Low Pass Slope
>
"SUB-W" "SLOPE"
Subwoofer Phase
>
"SUB-W" "PHASE"
1
Enter X'Over setting mode
1 sec., and select "DSP"
Press [ ]
"X'OVER".
Press the [AUD] knob.
• For how to select Function Control items, refer to
<Function Control> (page 10).
2
Select the speaker you want to set
Turn the [AUD] knob and push the center.
"FRONT"/ "REAR"/ "SUB-W"
3
Select the item you want to set
Turn the [AUD] knob and push the center.
4
Set the X'Over value
Turn the [AUD] knob and push the center when
the desired value is displayed.
5
Exit X'Over setting mode
Press the [ ] button twice.
Range
"THRU" (Through)/ 30/ 40 / 50/
60/ 70/ 80/ 90/ 100/ 120/ 150/
180/ 220/ 250 Hz
-6/ -12/ -18/ -24 dB/Oct.
30/ 40/ 50/ 60/ 70/ 80/ 90/ 100/
120/ 150/ 180/ 220/ 250 Hz/
"THRU" (Through)
-6/ -12/ -18/ -24 dB/Oct.
REVERSE (180°)/ NORMAL (0°)
> >
"SETUP"

DTA (Digital Time Alignment) Setting

Adjusting fine tuning of the speaker position
compensation value specified at <Cabin selection>
(page 28).
1
Enter DTA setting mode
1 sec., and select "DSP"
Press [ ]
"DTA".
Press the [AUD] knob.
• For how to select Function Control items, refer to
<Function Control> (page 10).
2
Select the speaker you want to set
Turn the [AUD] knob and push the center.
"FRONT" (Front speaker)/ "REAR" (Rear speaker)/
"SUB-W" (Subwoofer )
3
Set the compensation value of the speaker
position
Turn the [AUD] knob and push the center when
the desired value is displayed.
Adjust between 0 and 14.44 feet.
✍
Refer to <Appendix> (page 34) on how to set
the compensation value.
4
Exit DTA setting mode
Press the [ ] button.
> >
"SETUP"
29
|
English