Boot Sequence Recovery Mode - Aastra 480i Administrator's Manual
Sip ip phone release 1.4.1
Hide thumbs
Also See for 480i:
- Administrator's manual (264 pages) ,
- User manual (95 pages) ,
- Release notes (60 pages)
Table of Contents
Advertisement
Advanced Operational Features
Advanced Operational Features
Boot Sequence Recovery Mode
You can force the IP phone into recovery mode by pressing the 1 and # keys
during boot up when the logo displays. This feature is enabled by default on the IP
phone.
You can disable this feature using the following parameter in the configuration
files:
•
force web recovery mode disabled
Valid values for this parameter are 0 (false) and 1 (true). Default is 0 (false).
A boot counter increments after each faulty boot. When the counter reaches a
predetermined value, it forces Web recovery mode. The counter is reset to zero
upon a successful boot.
The predetermined value is set using the following parameter in the configuration
files:
•
max boot count
A zero (0) value disables this feature. The default value is 10.
You can configure the boot sequence recovery mode parameters using the
configuration files only.
Configuring Boot Sequence Recovery Mode
Configuration Files
For the specific parameters you can set in the configuration files for boot sequence recovery mode, see
Appendix A, the section,
41-001129-00 Rev 09, Release 1.4.1
DFW Phone 972-992-4600
"Boot Sequence Recovery Mode."
on
page A-105.
6-7
Advertisement
Table of Contents
Troubleshooting
