Epson L200 Service Manual page 32

L200/L201/L100/L101
CR Encoder
Step 2
Main Frame
Holder FFC
Hole
Head FFC
When installing the Head FFC to the Carriage, route the Head FFC through the rib (x1) on the rear of the Carriage, and connect the Head FFC to the CR
Encoder.
When installing the Head FFC to the Main Frame, route the Head FFC in the procedure below and connect it to the Main Board.
1. Align the fold line of the Head FFC with the rib (x1) of the Holder FFC, and route the FFC through the Holder FFC as shown in the figure above.
2. Route the Head FFC through the hole of the Main Frame.
3. Align the hooks (x4) of the Holder FFC with the holes (x4) on the Main Frame, and secure the Holder FFC to the Main Frame by sliding it to the 80-digit side.
Panel Board (L100/L101)
Upper Housing
Panel Board
Panel FFC
Ferrite Core
When routing the Panel FFC, follow the instructions below.
1. Route it through the Ferrite Core and the hook (x1).
2. Secure the FFC with double-sided tape (x2) to the Upper Housing, and then secure the Ferrite core with the hooks (x2).
Disassembly/Assembly
Head FFC
Step 1
Holder FFC
Fold line
Head FFC
Step 3
Main Frame
Holder FFC
Rib
Head FFC
Hook
Upper Housing
Panel FFC
Hook
Double-sided tape (8 x 20 mm)
PF Motor
PF Motor cable
PF Motor
Set the Ferrite Core of the PF Motor cable into the ribs of the Frame Base.
Routing FFCs/cables
Ferrite Core
Rib
Revision A
32
Confidential