Epson L200 Service Manual page 25

L200/L201/L100/L101
LD Roller Assy / LD Roller
Step 1 Step 2
Gear 23T
Shaft Gear 24T
Step 2, 3
Pick Assy
Bearing Concave section Shaft Gear 24T
When removing the LD Roller Assy, follow the procedure below.
1. Release the hooks (x2) and remove the Gear 23T.
2. Release the hooks (x2) and slide the Shaft Gear 24T to the 0-digit side until the concave section of the gear comes to the bearing part of the
Pick Assy.
3. Remove the LD Roller Assy upward.
When removing the LD Roller, remove the screws (x2) shown in the figure above.
When install the Torsion Spring, make sure to align the leg to the position as shown above.
Carriage
Compression Spring Compression Spring
Guide Carriage
Grounding Plate
Protrusion
Positioning Hole and Dowel
Hook
When replacing the Carriage, be careful about the following and
remove the Grounding Plate, Guide Carriage, Compression Springs
from the Carriage to be replaced, then attach them to the new
Carriage as shown in the figure above.
Insert the protrusion of the Grounding Plate to the hole of the
Carriage, and align the dowels (x3) of the Carriage with the
positioning holes (x3) of the Grounding Plate.
Secure hooks (x2) of the Guide Carriage by attaching them on
the holes (x2) of the Carriage.
Disassembly/Assembly
LD Roller Assy
LD Roller LD Roller Assy
Torsion Spring
C.B.P-TITE SCREW 3x8 (TBD)
C.F.B-TITE SCREW 3x5 (TBD)
Hook
Porous Pad Front Paper Guide
Standard surface:
In the area with concaves and convexes on the
Porous Pad Front Paper Guide, use the level
of the concave section as a standard surface.
When installing the Porous Pad Front Paper Guide, align the pad
with the ribs and protrusions of the Platen. After installing the pad,
make sure to fit it evenly 1.5mm lower than the standard surface.
Details of Disassembling/Reassembling by Parts/Unit
Friction Buckler
Friction Buckler R Friction Buckler
Housing Bucklers
Leg of the
spring
Friction Buckler R
When installing the Friction Buckler and Friction Buckler R to the Housing Buckler, pay attention to the following instructions.
• Remove the Sheet BF2-A on the rear side of the Friction Buckler to be replaced, and secure the removed sheet with double-sided tape to the
new Friction Buckler.
• Install the friction bucklers to the Housing Bucklers with the cutouts facing forward.
Install the buckler to the position as shown above.
Jam Cover
Jam Cover
Rib
Protrusion
When removing the Jam Cover, be careful not to lose the spring
installed to the dowel on the right side.
Housing Buckler
Sheet BF2-A
Double-sided
tape
Friction Buckler
Cutouts
Housing Buckler (Friction Buckler R)
Jam Cover
Spring
The USB Cover cannot be re-used once it is removed. Whenever
the cover is removed, make sure to replace it with a new one.
When removing the USB Cover, cut the hook securing the USB
Cover with a nipper. Be careful not to damage the Upper Housing
then.
Revision A
Housing Buckler (Friction Buckler)
USB Cover
USB Cover
Hook
25
Confidential