Details Of Disassembling/Reassembling By Parts/Unit - Epson L200 Service Manual

L200/L201/L100/L101
1.3

Details of Disassembling/Reassembling by Parts/Unit

Panel Unit (L200/L201)
Panel Unit
Panel FFC
Do not lift the Panel Unit too fast, since the Panel FFC is connected
to the back of the Panel Unit.
Spacer
Be careful not to lose the Spacer because it comes off easily when disassembling the CIS.
When installing the spacers, be sure to place them with the cutout facing inward.
Align the toothed side of the Timing Belt with the same shaped rib of the backside of the CIS, and secure the Timing Belt with Torsion Spring.
Disassembly/Assembly
Document Pad (L200/L201)
Document Cover
Document Pad
Origin Position
When installing the Document Pad, follow the procedure below.
1. Place the Document Pad with the side where the double-sided
tape attached upward on the document glass aligning its corner
with the origin position.
2. Close the Document Cover to attach the Document Pad.
CIS (L200/L201)
Backside of the CIS
CIS
Torsion Spring
Details of Disassembling/Reassembling by Parts/Unit
Scanner
Unit
Panel FFC
Standard line
Double-sided tape
Do not lift the Scanner Unit too fast, since the Panel FFC, Scanner Motor cable and Scanner FFC are connected to the rear side of the Scanner Unit.
Tighten the screws in the order indicated in the figure above.
Timing Belt
Toothed
side
PE Sensor Lever
Take care not to damage the PE Sensor Lever.
Align the ribs (x3) of the Main Frame with the cutouts of the Main Board.
Screw one side of the grounding wire (w/ ferrite core) together with the plate of the PF Motor, and the other side together with the Main Board.
Scanner Unit (L200/L201)
1
Scanner FFC
Scanner Motor cable
3
Main Board
Main Board
Grounding wire Plate of PF Motor
Revision A
2
4
Scanner Unit
C.B.P-TITE SCREW 3x10 (5.0 ± 0.5 kgf·cm)
Main Board
Rib
C.B.S-TITE SCREW 3x5 (7.5 ± 0.5 kgf·cm)
C.B.P-TITE SCREW 3x8 (5.0 ± 0.5 kgf·cm)
23
Confidential