Epson L200 Service Manual page 30

L200/L201/L100/L101
Upper Housing Assy / Ink Supply Holder Assy (L100/L101)
Left side Step 1
2
1
Ink Supply Holder Assy
Hook
C.B.P-TITE SCREW 3x6 (5.0 ~ 6.0 kgf·cm)
Step 4
Left side
Ink Supply Holder Assy
5.0 mm
30.0 mm
Voluntary Label
Do not lift the Upper Housing Assy too fast, since the Panel FFC is connected to the back of the Upper Housing Assy.
Be careful not to damage the hooks (x2) on the bottom left because these cannot be seen when removing.
Follow the procedure below when removing the Upper Housing Assy.
1. Remove the screws (x2) that secure the Ink Supply Holder Assy.
2. Remove the screws (x2) that secure the Upper Housing Assy.
3. Release the hooks (x8) that secure the Upper Housing Assy.
4. Lift the Upper Housing Assy while leaving the Ink Supply Holder Assy.
5. Disconnect the Panel FFC from the connector on the main board, and remove the Upper Housing Assy.
When replacing the Upper Housing Assy, peel off the Voluntary Label from the old housing and attach it to the new housing as specified in the
figure above.
When installing the Ink Supply Holder Assy, align the hooks (x4) of it with the holes of the Upper Housing Assy and then tighten the screws in
the order indicated in the figure above.
Disassembly/Assembly
Bottom side Step 3 Upper Housing Assy
Rear side Step 2
Upper Housing Assy
C.B.P-TITE SCREW 3x10 (5.0 ± 0.5 kgf·cm)
Step 5
Upper Housing Assy
Panel FFC
Details of Disassembling/Reassembling by Parts/Unit
Refilling Ink Label (L100/L101)
4.0 mm
Hook
Upper Housing Assy
23.2 mm
Attach the Refilling Ink Label on the position shown in the figure
above.
Ink Tube Guide 1st
C.B.P-TITE SCREW 2.5x5
(5.0 ~ 6.0 kgf·cm)
Follow the procedure below when removing the Ink Supply Holder Assy / Ink Tube Guide 1st.
1. Remove the Upper Housing Assy.
2. Peel off the acetate tape (x2) that secure the Ink Tube Guide 1st.
3. Remove the screw (x1) that secures the Ink Tube Guide 1st.
4. Release the hooks (x2) that secure the Ink Tube Guide 1st, and remove it from the frame.
5. After confirming the Valve is closed, disconnect the Ink Tubes from the Joint.
6. Pull out the Ink Tubes from the holes of the Ink Supply Holder Assy / Ink Tube Guide 1st, and remove the Ink Supply Holder Assy / Ink Tube
Guide 1st.
10.0 mm
4.0 mm
Refilling Ink Label
Be careful when removing the Printer Cover, because the hooks
(x2) are fragile and easily get damaged or softened.
Ink Tube Guide 1st / Ink Supply Holder Assy (L100/L101)
Joint
Ink Tube
Ink Tube Guide 1st Hook
(p 30)
(p 27)
(p 10)
Revision A
Printer Cover (L100/L101)
Hook
Printer Cover
Holes
Ink Tube
Ink Tube Guide 1st
Ink Supply Holder Assy
30
Confidential