Start Recording - Kenwood RDX-VH7 Instruction Manual

Temporary stop during recording
Cassette deck only
recording
Lights
÷ Press the "¶ rec/arm" to restart recording.
To end recording
Cassette deck
Each press switch the modes as
follows.
rev.mode
Dolby NR
4 4
Dolby NR
Lights
Lights
4. Set the recording condition.
1
Select the reverse mode.
""" lit ..... Tape stops after having recorded the two sides.
Goes off ..... Tape stops after having recorded one side of
2
Select the Dolby NR mode.
"B-type" ... Tape is recorded using B Type.
"C-type" ... Tape is recorded using C Type.
Goes off..... Dolby NR is deactivated.
Lights

5. Start recording.

1
Press the "¶ rec/arm" key.
5 5
Lights
2
Play (or tune) the input
source to be recorded.
÷ The recording level is adjusted auto-
matically when the "crls" function
is used.
÷ Recording stops automatically when
the tape side(s) to be recorded have
been fully recorded.
Recording onto cassette tape
An unrecorded portion of about 4 seconds is
produced
(auto recording mute)
To enter record-pause mode from stop mode
after leaving a non-recorded blank of about 4
seconds
1
Press the "7 stop" key to set the cassette
deck in stop mode.
2
Press the "¶ rec/arm" key twice.
Cassette deck only
recording
Blinks for 4 sec.
then lights steadily.
To enter record-pause mode from record mode
after leaving a non-recorded blank of about 4
seconds
Cassette deck only
Press the "¶ rec/arm" key during recording.
recording
Blinks for 4 sec.
then lights steadily.
tape.
recording
y
RD-VH7/X-VH7 (EN)
Press twice.
Lights
Lights
function indicator
Dolby NR direction
45