Timer Operation; O.t.t. Timer - Kenwood RDX-VH7 Instruction Manual

Timer operation

50
The following three kinds of timer operations are
available for use according to purposes.
÷ O.T.T. timer
÷ Program timer playback (AI timer playback) and
timer recording
÷ Sleep timer
Be sure to adjust the clock before setting the timer.

O.T.T. timer

By simply setting the ON time of O.T.T. timer playback, the power switched ON is switched OFF automati-
cally in one hour after the start of timer playback.
1
Select the desired source and adjust its vol-
ume.
2
Press the "mode" key.
3
Rotate the "multi control" knob to select
"TIMER SET ?", then press the "enter" key.
multi control
4
Rotate the "multi control" knob to select
"O.T.T. SET ?", then press the "enter" key.
5
Set the timer ON time by rotating the "multi
control" knob.
To put back
the time
6
Press the "enter" key.
7
Press the "TIMER" key on the remote con-
trol unit repeatedly until "O.T.T." appears.
8
Press the "on/standby" key to switch the
power OFF (standby).
(The "standby/timer" indicator lights in
green.)
mode
enter
\
\
multi control
To advance
the time
enter
TIMER
Adjust the clock before setting the timer.
SLEEP
TIMER
POWER
The program timer does not operate during
playback by the O.T.T. timer.
3
Timer setting selection
TIMERTSET?
TIMERSET??
5
ON time setting
O.T.T.
AAM117:00
÷ The ON time can be set in steps of 5 minutes.
To cancel O.T.T.
÷ Switch the power ON and press the "TIMER" key
repeatedly until "O.T.T." disappears.
÷ When the "TIMER" key is pressed repeatedly until
"O.T.T." disappears after the start of O.T.T. timer
playback, this will be changed to normal playback.
Timer operation
RD-VH7/X-VH7 (EN)
multi control
mode
RD-VH7
enter
on/standby
¡
Blinks
Blinks