Table of Contents
Advertisement
j}5\ _ _ - - - - -
~
946261-9701
u
(A) 137698A
o
EACH SCREW
IN MOST
REARWARD
HOLE
622.30 MM
(24.50 IN.)
,.....
o
EACH SCREW IN
FORWARD
HOLE
Figure 2-21. Rack Mount Slide ConfIgUration (Right Side Only)
u
9.
Coat threads of two 8-32 x 5/16-inch panhead screws with Grade C Loctite (or equivalent)
and install through each slide into keyed slide mounts.
10.
Adjust stabilizers installed in step 2 to prevent wobbling and to provide smooth slide
operation. Tighten stabilizers.
11. Attach latch assembly to disk drive with 8-32 x 5/8-inch panhead machine screws. No.8
lock washers and No. 8 flat washers. Leave screws slightly loose at this time.
12.
Insert knob through front panel and attach to latch assembly with an 8-32 x 5/8-inch
panhead machine screw, a No.8 internal-tooth lock washer, an 8-32 x 1/4-inch spacer,
and an 8-32 hex machine nut.
13.
Adjust latch so it catches front vertical rack rail, securely holds disk drive in retracted
position, and releases easily when knob is pushed to left.
2.4.2 INSTALLATION OF CABINET MOUNT DISK DRIVE. Installation of the cabinet mount
disk drive consists of placing the unit in the space provided for it and leveling the unit. Leveling
should be performed after the interconnection cables have been connected to the disk drive.
Level the cabinet as follows:
1.
Remove jack screws from plastic container.
2.
Lift one side of cabinet and support it high enough to insert jack screws.
3.
Start jack screws into threaded holes beside casters. Thread screws into holes far
enough to allow casters to touch floor when unit is lowered.
4.
Lower cabinet and repeat steps 2 and 3 for opposite side.
5.
Unscrew jack screws until casters are raised off floor.
2-28
Digital Systems Division
Advertisement
Table of Contents
