Table of Contents
Advertisement
TMS34010 C Compiler Package Installation
2.1.3
Installation for PC Systems with a Winchester Disk and Single
Diskette Drive
This procedure is for backup of the distribution diskettes on a second set of
floppy diskettes using a single floppy disk drive. Additionally, it is recom-
mended that the distribution diskettes be backed up on the Winchester, both
for speed of access, as well as for safety of the software.
MS-DOS 2.1 and PC-DOS 2.1 are operating system versions that support a
hierarchical file system. For these systems it is recommended that a subdirec-
tory for TMS3401 0 development tools be created.
Warning:
Prior to proceeding, make sure the distribution diskettes have
write-protect tabs applied to prevent the risk of destroying the
information on the diskettes.
To back up the distribution diskettes using the single floppy disk drive, follow
these steps:
1)
Making sure that the utility function DISKCOPY.COM is available for
execution, type:
DISKCOPY
A:
B:/F/V
2)
The DISKCOPY function prompts you to place the source diskette in
drive A. Place one of the distribution diskettes in drive A:.
The
DISKCOPY function accesses the disk to determine its type and format.
3)
You are then prompted to replace the source diskette in drive
A:
with the
destination diskette. Place a blank diskette in drive
A:.
The
IF
option of
the DISKCOPY function causes the destination diskette to be formatted
before copying, precluding the possibility of directory errors on the
backup diskette. The
IV
option checks the diskette for media errors.
4)
After DISKCOPY formats the. backup diskette, it prompts you to switch
back and forth between the source and destination diskettes, copying
the distribution diskette to the backup diskette. After each distribution
diskette has been copied, DISKCOPY prompts you for more diskettes to
copy. Respond YES until all the distribution diskettes are copied.
If you plan to place the TMS3401 0 software tools in a directory on the Win-
. chester disk as recommended, follow these steps:
1)
Create a subdirectory to contain the TMS34010 development tools by
typing:
MKDIR \GSPTOOLS
2)
Make the TMS34010 development tools directory the current directory
by typing:
CD \GSPTOOLS
2-3
Advertisement
Table of Contents
