Table of Contents
Advertisement
~-------
~
946261-9701
(A) 137261
PUSH
INWAR~
PWNGER, I NTER LOCK
SOLENOID RELEASE
Figure 2-44. Cartridge· Locks
NOTE
If no cartridge is to be installed for any long period of time, install
the dust cover received with the disk drive.
2.4.8.4 Removal of Disk Cartridge Following Power Failure or for Emergency. Removal of the disk
cartridge following power failure or in an emergency situation should be performed only by the
customer service engineer.
1.
Wait approximately three minutes for cartridge to stop spinning.
2.
Raise cartridge access cover (cabinet mount) or pull disk drive out of rack (rack
mount).
3.
Release pack locks by inserting a flat head screwdriver (or similar object) into hole on top
of pack lock (see Figure 2-44). Press solenoid plunger into solenoid and tilt pack lock.
4.
Pull back hold-down arms.
5.
Remove cartridge dust cover.
2-58
Digital Systems Division
Advertisement
Table of Contents
