ZyXEL Communications ZyWall USG 2000 User Manual page 743

from which zones SNMP can be used to access the ZyWALL. You can also specify
from which IP addresses the access can come.
Figure 501 System > SNMP
The following table describes the labels in this screen.
Table 238 System > SNMP
LABEL
Enable
Server Port
Get
Community
Set
Community
Trap
Community
Destination
Service
Control
#
Zone
Address
ZyWALL USG 2000 User's Guide
DESCRIPTION
Select the check box to allow or disallow the computer with the IP
address that matches the IP address(es) in the Service Control table to
access the ZyWALL using this service.
You may change the server port number for a service if needed, however
you must use the same port number in order to use that service for
remote management.
Enter the Get Community, which is the password for the incoming Get
and GetNext requests from the management station. The default is
public and allows all requests.
Enter the Set community, which is the password for incoming Set
requests from the management station. The default is private and allows
all requests.
Type the trap community, which is the password sent with each trap to
the SNMP manager. The default is public and allows all requests.
Type the IP address of the station to send your SNMP traps to.
This specifies from which computers you can access which ZyWALL
zones.
This the index number of the service control rule.
The entry with a hyphen (-) instead of a number is the ZyWALL's (non-
configurable) default policy. The ZyWALL applies this to traffic that does
not match any other configured rule. It is not an editable rule. To apply
other behavior, configure a rule that traffic will match so the ZyWALL will
not have to use the default policy.
This is the zone on the ZyWALL the user is allowed or denied to access.
This is the object name of the IP address(es) with which the computer is
allowed or denied to access.
Chapter 46 System
743