Firewall Rule Example Applications - ZyXEL Communications ZyWall USG 2000 User Manual

Chapter 20 Firewall
Firewall and VPN Traffic
After you create a VPN tunnel and add it to a zone, you can set the firewall rules
applied to VPN traffic. If you add a VPN tunnel to an existing zone (the LAN zone
for example), you can configure a new LAN to LAN firewall rule or use intra-zone
traffic blocking to allow or block VPN traffic transmitting between the VPN tunnel
and other interfaces in the LAN zone. If you add the VPN tunnel to a new zone (the
VPN zone for example), you can configure rules for VPN traffic between the VPN
zone and other zones or From VPN To-ZyWALL rules for VPN traffic destined for
the ZyWALL.
Session Limits
Accessing the ZyWALL or network resources through the ZyWALL requires a NAT
session and corresponding firewall session. Peer to peer applications, such as file
sharing applications, may use a large number of NAT sessions. A single client
could use all of the available NAT sessions and prevent others from connecting to
or through the ZyWALL. The ZyWALL lets you limit the number of concurrent NAT/
firewall sessions a client can use.
Finding Out More
• See Section 5.4.12 on page 94
• See Section 6.5.6 on page 121
of configuring user-aware access control
• See Section 6.7.3 on page 127
H.323 traffic from the WAN to the LAN.

20.1.3 Firewall Rule Example Applications

Suppose that your company decides to block all of the LAN users from using IRC
(Internet Relay Chat) through the Internet. To do this, you would configure a LAN
to WAN firewall rule that blocks IRC traffic from any source IP address from going
to any destination address. You do not need to specify a schedule since you need
312
for related information on the Firewall screens.
for an example of creating firewall rules as part
(Section 6.5 on page
for an example of creating a firewall rule to allow
ZyWALL USG 2000 User's Guide
115).