Connecting Wires To Terminals - Kenwood DPX501U Instruction Manual

Connecting Wires to Terminals

To connect these leads, refer to
the relevant instruction manuals.
To Kenwood disc changer/
External optional accessory
To External Display/
Steering remote
Fuse (10A)
8 6 4
7 5 3
8 6 4
7 5 3
Wiring harness
(Accessory1)
External amplifier control wire
(Pink/Black)
TEL mute wire (Brown)
If no connections are made, do not
let the wire come out from the tab.
Power control/Motor antenna
control wire (Blue/White)
Battery wire (Yellow)
Ignition wire (Red)
See next page
A-–7 Pin (Red)
A–4 Pin (Yellow)
Connector A
2
1
2
Connector B
1
AUX left input (White)
AUX right input (Red)
Sub Woofer left output (White)
(DPX701U only)
Sub Woofer right output (Red)
(DPX701U only)
Antenna Conversion Adaptor
(ISO–JASO) (Accessory3)
Antenna Cord (ISO)
Front left output (White)
Front right output (Red)
Rear left output (White) (DPX701U/DPX501U)/
Sub Woofer left output (White) (DPX501U only)
Rear right output (Red) (DPX701U/DPX501U)/
Sub Woofer right output (Red) (DPX501U only)
To "EXT.AMP.CONT. " terminal of the amplifier
EXT.
having the external amp control function.
CONT
Connect to the terminal that is grounded when
either the telephone rings or during conversation.
MUTE
To connect the Kenwood navigation system, consult
your navigation manual.
Connect either to the power control terminal
when using the optional power amplifier, or to the
P.CONT
antenna control terminal in the vehicle.
ANT.CONT
FM/AM antenna input
English
49
|