Adjusting The Detail Of Audio Control - Kenwood DPX501U Instruction Manual

Adjusting the detail of Audio
Control
Among the Basic Audio items, you can adjust the
Bass level, Middle level, and Treble level in detail.
1
Select the Basic Audio item
Select the desired item to be set in detail from
followings;
• Bass level
• Middle level
• Treble level
For how to select Basic Audio items, see <Audio
Control> (page 12).
2
Enter Detail adjustment mode of Audio
Control
Press the [VOL] knob for at least 1 second.
3
Select the Detail Audio item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4
Adjust the Detail Audio item
Turn the [VOL] knob.
Bass level
Adjustment Item Display
Bass Center Frequency "Bass FRQ"/
"BAS F"
Bass Q Factor "Bass QFactor"/
"BAS Q"
Bass Extend "Bass EXT"/
"B EX"
Middle level
Adjustment Item Display
Middle Center Frequency "Middle FRQ"/
"MID F"
Middle Q Factor "Middle
QFactor"/
"MID Q"
Treble level
Adjustment Item Display
Treble Center Frequency "Treble FRQ"/
"TRE"
5
Exit the Detail Audio Control mode
Press the [VOL] knob for at least 1 second.
Range
40/50/60/70/80/100/
120/150 Hz
1.00/1.25/1.50/2.00
OFF/ON
Range
0.5/1.0/1.5/2.0 kHz
1.00/2.00
Range
10.0/12.5/15.0/17.5 kHz
• When you set the Bass Extend to ON, low frequency
response is extended by 20%.
• You can exit the Audio Control mode at anytime
by pressing any button except for [VOL] and [ATT]
buttons.
13
|
English