Audio Setup; Speaker Setting - Kenwood DPX501U Instruction Manual

General features

Audio Setup

Setting the Sound system, such as Cross over
Network.
1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
3
Select the Audio Setup item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4
Setup the Audio item
Turn the [VOL] knob.
Adjustment Item Display
Front High Pass Filter* 2 "HPF-F Fc"/
"HPF"
2
Rear High Pass Filter* "HPF-R Fc"/
"HPR"
1,2
Low Pass Filter* "LPF-SW"/
"LPF"
Subwoofer Phase* 1,2,3 "SW Phase"/
"PHAS"
Volume offset "Vol-Offset"/
"V-OFF"
Loudness "LOUD"
Dual Zone System "2 ZONE"/
"2ZON"
• Volume offset: Sets each source's volume as a
difference from the basic volume.
• Loudness: Compensates for low and high tones
during low volume.
1
• * You can control this item when <Switching preout>
(page 37) is set to "SWPRE SW". (DPX501U only)
• * 1 You can control this item when <Subwoofer
Output> (page 15) is set to "SW ON".
• * 2 You can control this item when "2 ZONE"/ "2ZON" of
<Audio Setup> (page 14) is set to "OFF".
3
• * You can control this item when Low Pass Filter is not
set to Through.
• Dual Zone System
Main source and sub source (Auxiliary input) output
Front channel and Rear channel separately.
- Set up the channel of sub source by <Dual Zone
System Setting> (page 37).
- Select Main source by [SRC] button.
- Adjust the volume of Front channel by [VOL] knob.
14
|
English
Range
Through/40/60/80/100/120/
150/180/220 Hz
Through/40/60/80/100/120/
150/180/220 Hz
50/60/80/100/120/
Through Hz
Reverse (180°)/ Normal (0°)
–8 — ±0
OFF/ON
OFF/ON
- Adjust the volume of Rear channel by <Audio
Control> (page 12).
- The Audio Control has no effect on sub source.
• You can use the Dual Zone System with the internal
auxiliary input.
5
Exit Audio Setup mode
Press the [VOL] knob for at least 1 second.

Speaker Setting

Fine-tuning so that the System Q value is optimal
when setting the speaker type.
1
Enter Standby
Press the [SRC] button.
Select the "STANDBY" display.
2
Enter Speaker Setting mode
Press the [VOL] knob.
"SP SEL"/ "SP" is displayed.
3
Select the Speaker type
Turn the [VOL] knob.
Each time you turn the knob, the setting
alternates between the settings shown in the
table below.
Speaker type Display
OFF "OFF"/ "SP OFF"
For 5 & 4 in. speaker "5/4 inch"/ "SP 5/4"
For 6 & 6x9 in. speaker "6x9/6 inch"/ "SP 6*9/6"
For the OEM speaker "O.E.M."/ "SP OEM"
4
Exit Speaker Setting mode
Press the [VOL] knob.