Kenwood DPX501U Instruction Manual page 58

Mecha Error/ E-99:
Something is wrong with the disc
magazine. Or the unit is malfunctioning for
some reason.
➪ Check the disc magazine. And then
press the reset button on the unit. If
the "Mecha Error/ E-99" code does not
disappear, consult your nearest service
center.
Hold Error/ HOLD:
The protective circuit in the unit activates
when the temperature inside the
automatic disc changer exceeds 60°C
(140°F), stopping all operation.
➪ Cool down the unit by opening
the windows or turning on the air
conditioner. As the temperature falls
below 60°C (140°F), the disc will start
playing again.
No Name: Attempted to display DNPS during the CD
play having no disc names preset.
Waiting/ WAITING:
Radio text data is being received.
Load/ LOAD: Discs are being exchanged in the Disc
changer.
Reading/ READING:
The unit is reading the data on the disc.
IN (Blink): The CD player section is not operating
properly.
➪ Reinsert the CD. If the CD cannot be
ejected or the display continues to flash
even when the CD has been properly
reinserted, please switch off the power
and consult your nearest service center.
Protect/ PROTECT (Blink):
The speaker wire has a short-circuit or
touches the chassis of the vehicle, and
then the protection function is activated.
➪ Wire or insulate the speaker cable
properly and press the reset button.
Unsupported File/ NA FILE:
An Audio file is played with a format that
this unit can't support.
➪ ----
Copy Protection/ COPY PRO:
A copy-protected file is played.
➪ ----
DEMO MODE (Blink):
The Demonstration mode has been
selected.
➪ The <Demonstration mode Setting>
(page 44) is ON. Turn it OFF.
No Device/ NO DVICE:
The USB device is selected as a source
although no USB device is connected.
➪ Change the source to any source other
than USB. Connect an USB device, and
change the source to USB again.
N/A Device/ NA DVICE:
An unsupported USB device is connected.
➪ For the supported USB devices, refer to
<About USB device> (page 10).
No Music Data/ NO MUSIC:
• The connected USB device contains no
playable audio file.
• Media was played that doesn't have data
recorded that the unit can play.
➪ Use media that has data recorded that
the unit can play.
USB Error/ USB ERR:
The connected USB device is rated a
current capacity higher than the allowable
limit.
➪ Check the USB device with reference to
<About USB device> (page 10).
Some trouble may have occurred to the
connected USB device.
➪ Remove the USB device and then
reconnect it. When the same message
displays again, use another USB device.
57
|
English