Display Illumination Control; Dimmer; Switching Preout; Built-In Amp Setting - Kenwood DPX501U Instruction Manual

Display Illumination Control

This function turns off the display when you
perform no operation for 5 seconds. This function
is effective when you are driving at night.
Display Setting
"Display : ON"/ Keeps the display on.
"DISP ON"
"Display : OFF"/ Turns off the display when you perform no
"DISP OFF" operation for 5 seconds.
• Set the Display Illumination Control when the
<Demonstration mode Setting> (page 44) is set to
OFF.
• When the display is off, pressing any key will turn on
the display.
• When the display is off, you cannot perform any
operation except for the following:
• Volume
• Attenuator
• Selecting the source
• Ejecting the disc
• Turning off the power
• During function control, such as the Menu System, the
display stays on.
In Standby mode

Dimmer

Dimming this unit's display automatically when
the vehicle light switch is turned ON.
Display
"Dimmer : ON"/ "DIM ON"
"Dimmer : OFF"/ "DIM OFF"
Setting
The display dims.
The display doesn't dim.
Function of the DPX501U
In Standby mode

Switching preout

Alternating the preout between the rear and
subwoofer. (With the subwoofer the sound
outputs without being effected by fader control.)
Display Setting
"SWPRE R" Rear preout.
"SWPRE SW" Subwoofer preout.
In Standby mode

Built-in Amp Setting

Controlling the built-in amplifier.
Turning OFF this control enhances the preout
quality.
Display Setting
"AMP : ON"/ "AMP ON" The built-in amplifier activates.
"AMP : OFF"/ "AMP OFF" The built-in amplifier deactivates.
Other than Standby mode/
When the Dual Zone System is ON

Dual Zone System Setting

Setting the Front channel and Rear channel
sound in the Dual Zone System.
Display Setting
"Zone2 : Rear"/ Sub source (Auxiliary input source) is to be rear
"ZONE2 R" channel.
"Zone2 : Front"/ Sub source (Auxiliary input source) is to be front
"ZONE2 F" channel.
37
|
English