Acs Module - Can-Am 2010 DPS Technical Manual

ACS MODULE

ACS Module Signal Circuit Continuity
Test
1. Remove seats and RH side panel.
2. Disconnect multifunction gauge from vehicle.
LIGHTS, GAUGE AND ACCESSORIES
Refer to
subsection of the appropriate Shop Manual.
3. Disconnect ACS module connector.
vmr2010-004-011_a
1. Module connector
4. Set the
FLUKE 115 MULTIMETER (P/N 529 035
to .
868)
5. Measure resistance as per the following tables.
TEST PROBES
Gauge pin 18 (BK/BE)
Module pin 5 (BE/GN)
TEST PROBES
Gauge pin 19 (BE/GN)
Module pin 6 (WH/BE)
ACS Module Input Voltage Test
1. Remove seats and RH side panel.
2. Disconnect module connector.
vmr2010-004
Subsection 02 (AIR CONTROLLED SUSPENSION (ACS))
RESISTANCE
Close to 0
RESISTANCE
Close to 0
Section 01 TECHNICAL MANUAL
vmr2010-004-011_a
1. Module connector
3. Set the
FLUKE 115 MULTIMETER (P/N 529 035
to Vdc.
868)
4. Place ignition switch to ON position.
5. Measure voltage as per the following table.
TEST PROBES
Pin 12 (OR/GN)
Battery negative (-) post
ACS Module Ground Test
1. Remove seats and RH side panel.
2. Disconnect module connector.
vmr2010-004-011_a
1. Module connector
3. Set the
FLUKE 115 MULTIMETER (P/N 529 035
to Vdc.
868)
4. Place ignition switch to ON position.
5. Measure voltage as per the following table.
TEST PROBES
Pin 7 (BK)
Battery positive (+) post
VOLTAGE
Battery voltage
(± 12 Vdc)
VOLTAGE
Battery voltage
(± 12 Vdc)
35