Can-Am 2010 DPS Technical Manual page 46

vmr2010-004-101_a
1. Actual setting (pressure transducer reading)
8. Measure voltage between compressor connec-
tor terminals as per the following table.
TEST PROBES
Pin C (BE/VI)
Pin A (BK)
ACS Compressor Removal
1. Release air pressure, refer to
PRESSURE IN SYSTEM FOR SERVICING
subsection.
2. Remove LH side panel.
3. Remove storage tray.
vmr2010-004-013_a
1. Storage tray
4. Remove solenoid valve. Refer to
NOID VALVE REMOVAL
5. Remove manifold. Refer to
REMOVAL .
6. Remove module. Refer to
MOVAL
.
7. Remove connector of auxiliary line pressure
transducer from support.
vmr2010-004
Subsection 02 (AIR CONTROLLED SUSPENSION (ACS))
VOLTAGE
Battery voltage
(± 12 Vdc)
RELEASING AIR
in this
ACS SOLE-
.
ACS MANIFOLD
ACS MODULE RE-
Section 01 TECHNICAL MANUAL
vmr2010-004-014_a
1. Connector of auxiliary line pressure transducer
8. Disconnect compressor connector.
vmr2010-004-015_a
1. Compressor connector
9. Disconnect the following hoses from compres-
sor air fittings.
– Compressor air inlet hose
– Compressor air outlet hose
– Auxiliary line hose.
vmr2010-004-016_a
1. Compressor air inlet hose
2. Compressor air outlet hose
3. Auxiliary line hose
39