Acs Hoses - Can-Am 2010 DPS Technical Manual

Section 01 TECHNICAL MANUAL
Subsection 02 (AIR CONTROLLED SUSPENSION (ACS))
vmr2010-004-108
Pressure Transducer Ground Test
1. Remove seats and RH side panel.
2. Disconnect pressure transducer connector.
vmr2010-004-104_a
1. Pressure transducer connector
3. Set the
FLUKE 115 MULTIMETER (P/N 529 035
to Vdc.
868)
4. Place ignition switch to ON position.
5. Measure voltage as per the following table.
TEST PROBES
Pin 1 (BK/GY)
Battery positive (+) post
Refer to the following illustration for the pressure
transducer connector pinout.
vmr2010-004-108
Pressure Transducer Replacement
1. Release air pressure, refer to
PRESSURE IN SYSTEM FOR SERVICING
subsection.
2. Disconnect pressure transducer connector.
3. Remove Oetiker clamp.
44
VOLTAGE
Battery voltage
(± 12 Vdc)
RELEASING AIR
in this
4. Remove pressure transducer from hose.
vmr2010-004-030_a
1. Auxiliary line pressure transducer
2. Connector
3. Oetiker clamp
5. Install a new pressure transducer on hose.
6. Install a new Oetiker clamp using
ERS (P/N 295 000 070)
7. Connect pressure transducer connector.
8. Ensure that there is no air leaks from pressure
transducer hose. Refer to
TEST (WITH B.U.D.S.)

ACS HOSES

ACS Hose and Fitting Replacement
1. Release air pressure, refer to
PRESSURE IN SYSTEM FOR SERVICING
subsection.
2. Locate hose or fitting to be replaced.
3. Remove it from vehicle.
4. Install the new hose or fitting.
5. Perform a ACS SYSTEM LEAK TEST (WITH
B.U.D.S.) .
Auxiliary Line Adapter Replacement
1. Release air pressure, refer to
PRESSURE IN SYSTEM FOR SERVICING
subsection.
2. Disconnect auxiliary line hose from adapter as
follows:
2.1 Push fitting ring toward adapter.
2.2 Hold ring in place.
2.3 Pull air hose.
OETIKER PLI-
.
ACS SYSTEM LEAK
.
RELEASING AIR
in this
RELEASING AIR
in this
vmr2010-004