Gigaset A580 IP User Manual page 152

Hide thumbs Also See for A580 IP:
Table of Contents

Advertisement

Customer service & product warranty – Australia and New Zealand
"Base" is flashing in the display.
1. The handset is out of range of the base station or the base station's range has decreased
because Eco mode is active.
¥
¥
Move the handset closer to the base station.
If necessary, deactivate Eco mode (
¥
2. The handset has been de-registered.
Register the handset (
3. The base station is not switched on.
¥
Check the base station's mains adapter (
¥
4. The base station firmware is currently being updated (automatically).
Please wait until the update is complete.
Handset does not ring.
¥
The ringer is deactivated.
Activate the ringer (
You cannot hear a ringer/dialling tone from the fixed line network.
The phone cord supplied has not been used or has been replaced by a new cord with the
¥
wrong pin connections.
Please always use the phone cord supplied or ensure that the pin connections are correct
when purchasing from a retailer (
Error tone sounds after system PIN prompt.
You have entered the wrong system PIN.
¥
Re-enter system PIN.
¥
Have you forgotten the system PIN?
Reset the base station to set the system PIN back to 0000 (
The other party cannot hear you.
You have pressed the k key or the
¥
§On§
Press the
display key to re-activate the microphone (
£
When making calls from the fixed line network, the caller's phone number is not displayed
although CLIP (
Page
Calling Line Identification is not enabled.
¥
The caller should ask his network provider to enable Calling Line Identification (CLI).
You hear an error tone when keying an input (a descending tone sequence).
¥
Action has failed/invalid input.
Repeat the operation.
Watch the display and refer to the user guide if necessary.
You cannot connect to the router and the phone is assigned a static IP address.
¥
Check on the router whether the IP address is already being used by another device in the
LAN or belongs to the block of IP addresses that is reserved on the router for dynamic
¥
address assignment.
If necessary, change the phone's IP address (
£
Page
£
Page
75).
£
Page
86).
£
Page
161).
§Mute§
display key. The handset is "muted".
42) is set.
72).
£
Page
18).
£
Page
£
Page
46).
£
Page
94).
89).
151

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents