Premio Computer Athena system System Manual page 98

Resume On KBC (with "Wake-Up Key" and "Wake-Up Password"),
Resume On PS/2 Mouse
These fields specify whether the system will be awakened from power
saving modes when activity or input signal of the specified hardware
peripheral or component is detected. Settings: S3, Disabled.
Note:
1. For "Wake-Up Key" function, the option "Specific Key" refers to
the password you specify in the "Wake-Up Password" field. Once
you set up a password, it will disable "Resume on PS/2 Mouse".
2. For "Resume On PS/2 Mouse" function, you need to click the
mouse to power on the system if the function is enabled.
Wake Up On Ring/PME
When setting to Enabled, these two features allow your system to be
awakened from the power saving modes through modem or any event on
PME (Power Management Event). Both features support S1~S5 modes.
However, to enable the "Wake Up On Ring" feature, you need to install a
modem card supporting power on function. Settings: Enabled, Disabled.
Resume By Alarm
This is used to enable or disable the feature of booting up the system on
a scheduled time/date from the soft off (S5) state. Settings: Enabled,
Disabled.
Alarm Date/Hour/Minute/Second
If Resume By Alarm is set to Enabled, the system will automatically
resume (boot up) on a specific date/hour/minute/second specified in
these fields. Available settings for each item are:
Alarm Date
Alarm Hour
Alarm Minute
Alarm Second
Note: If you have changed this setting, you must let the system boot
up until it enters the operating system, before this function will
work.
01 ~ 31, Every Day
00 ~ 23
00 ~ 59
00 ~ 59
3-21
BIOS Setup