Maintaining The Appliance; Maintaining The Filter Screen Of The High-Pressure Cleaner - Ryobi R2-PWWDV-G Original Instructions Manual

9.1 Maintaining the filter screen of the high-pressure cleaner

WARNING: Danger of injury! Switch the appliance off and pull the appliance plug out of the socket.
Release pressure reserves by holding down the spray button until no more water comes out. You can
avoid injuries in this way.
CAUTION: Danger of material damage! Consider that there is still water in the garden hose. Disassemble
the garden hose outside.
52
1. Release the garden hose from the high pressure cleaner by pulling the quick connector towards you (Fig. 52).
2. Twist off the adapter of the quick coupling from the high-pressure cleaner (Fig. 53).
NOTE: If you cannot release the adapter using your hands alone, carefully use pipe tongs.
3. Allow plenty of water to flow through the large opening of the adapter.
- If this is not enough, pull the filter screen out of the adapter (Fig. 54).
- Clean the filter screen thoroughly using a brush with plastic bristles.
- It might also be necessary to decalcify the screen.
- If the dirt is stubborn or if there is a defect, you have to replace the screen, Chapter 10.3,
"Accessories, spare parts and reference sources".
- Now put the filter screen back in.
4. Screw the adapter back onto the high-pressure cleaner until finger tight (Fig. 53).

Maintaining the appliance

53 54
43