Assembly - Ryobi R2-PWWDV-G Original Instructions Manual

Unpacking And Assembling

3.2 Assembly

WARNING: Danger of injury! Only assemble the appliance if it is not connected to the power supply.
Otherwise the appliance could start up accidentally and cause injury.
8
1. Mount the carrying handle by
screwing in at the handle 2 of the
screws delivered into each brace
(Fig. 8).
NOTE: Tighten the screws by hand.
NOTE: If you have not done so
already, take the wet/dry vacuum
cleaner up and out of its holder and
put it to one side. The high-pressure
cleaner is easier to assemble if the
wet/dry vacuum cleaner has been
removed beforehand.
11
5. Put the upper pistol holder onto
the carrying handle you have just
mounted (Fig. 11).
20
9
2. Put the carrying handle you
have just assembled firmly onto the
two connecting pieces on the
high-pressure cleaner (Fig. 9) until
you can push no further.
12
6. Put the lower pistol holder onto
the high pressure cleaner as
shown (Fig. 12).
10
3. Screw on the carrying handle
with two screws on each side
(Fig. 10).
NOTE: Tighten the screws by hand.
4. By gently lifting, check whether
the carrying handle and high-
pressure cleaner are securely
fastened together.