Controller Features And Functions; Introduction; Anti-Crushing Device - Centsys D3 User Manual

Controller features and functions

Controller features and functions

Introduction

The electronic controller synchronizes the functions of the gate operator. Although
the controllers for each operator are marginally different, the functions and safety
features which are described below are similar.

Anti-crushing device

Gate closing
Gate closing into an obstruction
Gate opening
Gate opening
If the gate is obstructed repeatedly four times, either opening or closing, often referred
to as multiple collision, the gate will stop and will not respond to trigger inputs for two
minutes.
After this time the gate will once again respond to command signals. This function is a
warning to the user that the obstruction must be removed. (The number of obstruc-
tions before the system will shut down can be adjusted to suit, default is four).
Gate automatically reverses and re-opens
Gate stops on hitting the obstruction
Page 10
S T O P