OCEANUS DSC/ATIS_ENG_0512
TRANSMITTING
Note:
Channel 70 is DSC only. All the available marine channel are
located on page 49.
SETTING TX OUTPUT
Caution: It is important to remember to use the LO position in port or
1.
When you turn the radio On for the first
time, the unit is automatically set to
transmit at 25 watts (HI).
2.
Press HI/LO to change the transmitter
output to 1 watt (LO).
3.
Press HI/LO again to change back to 25
watts (HI).
Note:
Each time the HI/LO is pressed a short tone sounds.
When the channel is set as LO power channel, you can
transmit at 25 watts (HI) by pressing and holding HI/LO during
the call (except for CH75 and CH76).
5/12/05
10:34 AM
for short range communications.
Page 15
15