Specification - Uniden OCEANUS DSC Series Owner's Manual

OCEANUS DSC/ATIS_ENG_0512
General
Controls
Status Indicators
Channel Display
Buttons
Connectors
Size
Weight
Supply Voltage
Standard Accessories
Antenna Impedance
Microphone
Speaker
Operating Temperature Range
Shock and Vibration
Transmitter
Power Output
Power Requirement
Modulation
Hum and Noise Signal-to-Noise
Audio Distortion
Spurious Suppression
Output Power Stabilization
Frequency Range
Frequency Stability
Receiver
Frequency Range
Sensitivity
Circuit
Squelch Sensitivity
Spurious Response
Adjacent Channel Selectivity
Audio Output Power
Power Requirement
IF Frequencies
5/12/05 10:34 AM

Specification

: On-Off/Volume, Squelch
: TX (Transmit), TRI (Triple Watch),
HI (High), LO (Low), U, C, I, MEM, WX, DSC,
(Alarm),
: LCD with Orange backlight
: 16/9/TRI, DISTRESS, PA/MODE, MEM, SELECT,
STEP/SCAN, MENU, HI/LO
: Antenna, Remote, ACC, and DC power
: H63 mm x W160 mm x L168 mm (W/O Heat Sink)
H3.07 inches x W7.24 inches x L6.61 inches
: 1.0 kg / 2.65 lbs / 42.3 oz
: 13.8V DC negative ground
: Mounting bracket and hardware, DC power cord,
microphone hanger, spare fuse, ACC Cable
: 50 Ω nominal
: Rugged 2 kΩ condenser mic element with
coiled cord
: 1.82 inch, Mylar Cone 8 Ω
: –15 °C to + 55 °C (+5 °F to +131 °F)
: Meets or exceeds EIA standards, RS152B and
RS204C
: 1 watt or 25 watt (switch selectable)
: Not rated on LO, 25 watts output: 5.6A@13.8V DC
: FM ±5 kHz deviation
: 45 dB@1 kHz with 3 kHz deviation with 1000 Hz
modulating frequency (nominal)
: Less than 8% with 3 kHz deviation with 1000 Hz
modulating frequency
: –70 dBm @ Hi, –70 dBm @ Lo
: Built-in automatic level control (ALC)
: 156 to 158 MHz
: ±10 ppm @ –15°C to + 55°C
: 156 to 163 MHz
: 0.25 µV for 12 dB SINAD
: Dual Conversion Super Heterodyne PLL
: 0.8 µV Threshold
: 70 dB
: 75 dB @ ±25 kHz
: 2.8 watts (10% Distortion)
: 200 mA @ 13.8V DC squelched, 0.7A @ 13.8V DC
at maximum audio output
: 1st 21.4 MHz, 2nd –455 kHz
50
Page 50
(GPS), and Channel Display