Transmitting And Receiving; Selecting Channel Modes; Transmitting - Uniden Atlantis 150 Owner's Manual

1. Press SQL/UIC. SQL displays and the current squelch level
flashes.
2. Press SQL/UIC while the squelch level displays
in order to change the squelch level to the next
step (0 - 3, then repeating again from
3. Press and hold SQL/UIC to
squelch setting.
squelch setting.

TRANSMITTING AND RECEIVING

Selecting Channel Modes

The radio uses U.S., Canadian, and International Marine
Channels (modes). Press and hold SQL/UIC to change
modes. Each time you press and hold SQL/UIC, the mode
indicator changes (US - United States; CAN - Canada; none
- International). Refer to page 25 for a list of the available
channels and corresponding frequencies.
Each time you change the UIC mode, Triple Watch, EMG
CH16/CH9CH,
The system does not remember these settings between
NOTE
modes.
Memory channels are saved to their specific UIC mode.

Transmitting

The radio can transmit for up to 3 minutes. TX displays when
transmitting. After 3 minutes of continuous transmission,
transmission is canceled and an error tone sounds.
The radio transmits at 0.7W and 2.5W.
Boosting Transmission Power
1. Hold the radio approximately 2 inches in front of your mouth
with the antenna at approximately 45º angle away from your
head.
2. Press BOOST on the side of the radio
to change the transmit power from Low
E-14
save and
A 2 second timeout also exits
WX mode, and WX Alert mode are canceled.
Uniden Atlantis 150 Owner's Manual
0).
exit the
SQL
HI