Pre-Wire - Elan Via! 4.0 Installation Manual

VIA!4.0
INSTALLATION MANUAL
Installation - Pre-Wire (cont'd)
For applications where TVs and VIA! Touch panels display the same
video, use the Video Loop Out to daisy-chain VIA!s/TVs together as
shown below. Set the 75 Ohm Termination jumper(s) to the HI Z
position.
HI Z Position
For applications where different, independent video is displayed on
each VIA!/TV, run separate feeds of RG-6 or RG-59 from a video
switcher (ELAN Z•880 or S12) to each VIA!/TV as shown below.
Keep the 75 Ohm Termination Jumper in the 75 Ohm position.
Video Source
Page 16
From
Video
Source
75Ohm Factory
Default Position
From
© ELAN Home Systems 2005 • All rights reserved.
E L A N H O M E S Y S T E M S
HI Z Position
From
From
Video
Video
Source
Source
From
Video
Source