Removal From Wall - Elan Via! 4.0 Installation Manual

E L A N H O M E S Y S T E M S
Installation - Rough-In (cont'd)
Removal From Wall (Winglets Deployed)
1. Use a thin steel ruler or thumbnail to slip under the bottom edge
of the faceplate and gently pry it off the assembly.
2. Loosen the winglet screws until they retract inside the metal
mounting box. Look through the openings in the mounting
flanges to verify that the winglets have fully retracted. If they have
not fully retracted you can insert a small diameter screwdriver in
the adjacent hole to guide the winglets into the box. Do not apply
too much force on the winglets as they may cause damage to the
circuit board.
3. Gently pull the top of the VIA! assembly out of the wall first and
then slowly lift the rest of the assembly out of the wall. Stop
immediately if the winglets grab the drywall or fracturing of the
drywall may occur.
4. Lift the assembly up until the wires along the bottom edge are
exposed. Label, disconnect and tie off the wires to keep them
from dropping down inside the wall. Make sure to protect the
Touch Panel/LCD assembly and faceplate from damage when it
is not in the wall.
© ELAN Home Systems 2005 • All rights reserved.
INSTALLATION MANUAL
VIA!4.0 Front
VIA!4.0
Page 23