Installation And Setup; Positioning The Amplifier; Rack Mounting - Episode EA-AMP-12D-45A Installation Manual

45 watt, class d 12 channel amplifier
Table of Contents

Advertisement

EA-AMP-12D-45A Installation Manual

6. Installation and Setup

6.1. Positioning the Amplifier

Episode amplifiers are designed to help deliver a great audio experience that makes your music come alive
for years to come. However, where you place the amplifier can have a large effect on the performance you
receive and the life of the unit.
• Be sure that the unit is in a well-ventilated area that provides adequate cooling.
• Do not block the cooling vents located on both sides of the unit.
• Do not place the unit on carpeting or any similar material.
• Do not install the unit near a source of heat, or in an extremely humid or wet location.
• If the installation lacks good air flow (such as solid cabinet doors or wall-mounted racks), it may be
necessary to create ventilation to allow outside air into the space.
• Allow a minimum of 5" of free air space above the unit.
• Allow a minimum of 3" of free air space on either side of the unit. (Does not apply to rack mounting)
3in.

6.1.1. Rack Mounting

The EA-AMP-12D-45A includes hardware to rack-mount the amplifier. To prepare the amplifier, attach the
rack ears at the front left and right sides as shown below using the included screws. Tighten the screws tightly
with a screwdriver. Then, remove the feet on the bottom of the unit and store the feet and screws in case they
are needed later.
To mount the amplifier in the rack, 1-U of space is needed for placement, and 5 inches above the space should
be left open to allow for adequate ventilation. Install the amplifier so that the rear of the unit can be accessed for
connections and adjustments for the output zone.
Important! The amplifier chassis and rack ears are NOT designed to support anything other than
the amplifier. DO NOT stack components on top of the amplifier in a rack, as it could damage the
amplifier's chassis or block ventilation.
Pg. 10
Minimum of 3"
free air space on
each side.
Attach Ears using Supplied Screws
Minimum of 5"
5in.
free air space
above.
(4 on Each)
Remove Feet
3in.
2in.
© 2013 Episode
®

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents