Table of Contents
Advertisement
S
S
UPER
ERVER 5017R-MF User's Manual
1. Using a different machine, copy the "Super.ROM" binary image fi le into the
disc Root "\" Directory of a USB device or a writeable CD/DVD.
Note: If you cannot locate the "Super.ROM" fi le in your driver disk, visit
our website at www.supermicro.com to download the BIOS image into a
USB fl ash device and rename it to "Super ROM" for BIOS recovery use.
2. Insert the USB device that contains the new BIOS image ("Super.Rom") into
your USB drive and power on the system
3. While powering on the system, keep pressing <Ctrl> and <Home> simultane-
ously on your PS2 or USB keyboard until your hear two short beeps. This
may take from a few seconds to one minute.
4. After locating the new BIOS binary image, the system will enter the BIOS
Recovery page as shown below.
Note: At this point, you may decide if you want to start with BIOS Recovery. If you
decide to proceed with BIOS Recovery, follow the procedures below.
5. When the screen as shown above displays, using the arrow key, select the
item- "Proceed with fl ash update" and press the <Enter> key. You will see the
progress of BIOS Recovery as shown in the screen below.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Main
Advanced
WARNING! BIOS Recovery Mode has been detected
Flash Update Parameters
Reset NVRAM
Proceed with Flash Update
Version 2.12.1211. Copyright (C) 2011 American Megatrends, Inc.
Note: Do not interrupt the process of BIOS fl ashing until it is completed.
6. After the process of BIOS Recovery is complete, press any key to reboot the
system.
Event Logs
IPMI
Boot
Security
[Enabled]
B-2
Exit
Recovery
Recovery
Set this to start flash
update
:
Select Screen
:
Select Item
Enter:
Select
+/- :
Change Opt.
F1 :
General Help
F2 :
Previous Values
F3 :
Optimized Defaults
F4 :
Save & Exit
ESC :
Exit
Advertisement
Table of Contents
