Comfort Adjustments; Seat Height Adjustment; Quick Release Fasteners; To Change The Seat Height - Pride Go-Chair Owner's Manual

V . C O M F O R T

COMFORT ADJUSTMENTS

After becoming familiar with your travel chair's operation, you may find the need to make some adjustments to increase
your comfort, such as seat height, armrest width, foot platform depth and controller position. Use the steps below to make
comfort adjustments.
WARNING! If your Go-Chair was configured by an authorised Pride Dealer, please consult the healthcare
professional before changing the seat position or making any other adjustment. Some adjustments
may degrade your Go-Chair's performance and safety by changing its centre of gravity.
WARNING! Some Go-Chair components are heavy. Please refer to "Appendix I - Specifications"
for specific component weights before you disassemble the Go-Chair.
WARNING! Remove the occupant from the Go-Chair before making any adjustments.

Seat Height Adjustment

You can adjust the seat to two different heights. Seat height
adjustment requires the removal of the battery box.

To change the seat height:

1. Turn off the power to the controller.
2. Disconnect the controller connector from the power base.
3. Remove the seat.
4. Remove the battery box.
5. Loosen the quick release fastener. See figure 16.
6. Remove the clevis pin from the seat pedestal.
7. Reposition the seat pedestal to the desired height.
8. Reinstall the seat pedestal clevis pin.
9. Tighten the quick release fastener. See figure 17.
10. Reinstall the battery box.
11. Reinstall the seat.
12. Reconnect the controller connector.

Quick Release Fasteners

The quick release fastener removes excess play in the seat
pedestal. See figure 16. The quick release fastener consists
of a bolt, a lever and a nut. See figure 17. The lever has a
cam on the end that allows it to clamp into place. The quick
release fastener has two states: clamped and unclamped.
When the lever is open, the quick release fastener is
unclamped. When the lever is closed, the quick release fas-
tener is clamped.
To clamp the quick release fastener:
1. Make sure the lever is in the open position.
2. Turn the nut clockwise until it is snug.
3. Rotate the lever until it is in the fully closed position.
Go-Chair
A D J U S T M E N T S
QUICK RELEASE
FASTENER
Figure 16. Seat Height Adjustment
BOLT
LEVER (OPEN)
UNCLAMPED
Figure 17. Quick Release Fastener Operation
www.pridemobility.com
SEAT PEDESTAL
NUT
LEVER (FULLY CLOSED)
CLAMPED
CLEVIS PIN
CAM
23